Hi has anyone fitted a motor mover to this model I am thinking of Reich Move Control Economy single axle. I have a good idea as to where to get the MM but I need the Puck L adapter brackets and am finding them very elusive

Wish I had a definitive answer, I have a similar Puck L and I understand that the ground clearance is too low to fit a 'Mover' - I could be wrong !

We have just a Reich fitted to our Puck L.
It is low and worries Carole no end, but I don't see a problem with it as long as we drive slowly over road bumps and rough track.

Which model Motor mover have you had fitted and is it fitted in front or behind the axle.

There was a change in height about 2001/2002 - mine with the separate plastic Gas Bottle nose has a lower chassis to the later ones ,like hampshireman's, which will accept a 'Mover' - so it depends which model you have ! If a later one with integral Gas Bottle housing you should be OK !

Thanks for that I have a bull nose gas holder not inside, you think I cannot get mover fitted??

My Puck L was measured up by the Lechlade fitters and ok'd to fit the Reich comfort unit.
However I had the uprated axle so there was no payload problem But Mark the owner
vetoed the fitting due to previous complaints from a Puck L owner who had had one fitted.