New toilet Plash back
After Mrs B said i'm not going anywhere until you install some hot water and a shower !!. I could see the first time we used a shower the water was going to between the wall and the plash plash back and due the corners not fitting under the seal.
I tried to get the plash back out but it is stapled to the bulkheads so I cut it out leaving a strip of it in place even with the plash pack now free I couldn't fit it all in the window seal obviously a manufacturing fault, so I decided to replace it i looked online for something that would do the job to no avail so in the end i decided to make my own out off glass fibre.
I used a melamine board and these a the steps i took Bad fit .jpg - Bild entfernt (keine Rechte)Taped up and polished.jpg - Bild entfernt (keine Rechte)light gray Gel coat.jpg - Bild entfernt (keine Rechte)Glass and resin ready to go.jpg - Bild entfernt (keine Rechte)Resin rolled out.jpg - Bild entfernt (keine Rechte)Released from board.jpg - Bild entfernt (keine Rechte)