We have bought an eriba troll 540 from the Netherlands and haven’t even seen it! We need to replace the back cushions as the previous owner cut them to make two single beds. Could a kind person possibly send us the measurements so we can buy some replacement foam? Thanks

to another Troll. Sadly from your point of view we have a 530 too.

And I have a 540 but in storage till April ,sorry

We have a 2004 Troll 540, and its upright back cushions are rectangular pieces of foam zipped into heavy duty fabric. Each side has 2 of these, connected by 40mm strips of velcro. The approximate dimensions are:1620 mm long by 155mm high by 105 mm wide. There are 4 pieces altogether.
There is a single similar cushion which make up part of the front dinette single bed, and that is 860 long by110 mm high by 105 mm wide. This normally lives in the wardrobe. We did not get 2 loose square cushions from the previous owners.
I would add that our seat backs and beds are different lengths, being1540 mm long on the left side looking forwards, but that is to allow for the storage of the table against the cupboard, a feature found only around the time our troll was built.
I hope that this helps, good luck!
Nick

Thanks so much for all the info. We don’t seem to have the big table to store or the little chest of drawers that others have. It’s hard to work out what they actually cut or kept but at least the covers were folded and not chopped up.
I found some photos

6D30E62D-D970-4DB4-80A1-D4F9D292C6B1.png - Bild entfernt (keine Rechte)6D30E62D-D970-4DB4-80A1-D4F9D292C6B1.png - Bild entfernt (keine Rechte)6D30E62D-D970-4DB4-80A1-D4F9D292C6B1.png - Bild entfernt (keine Rechte)Hi, We have a Troll 540 with the multifunctional beds, so either two small singles, or two wider singles, or one large bed.
Our cushions on one side are split, attach together with Velcro. This is to facilitate making two wide singles. and you would put together to make the double bed. I’m attaching picture, if you look closely the back cushion on the right is two separate pieces, manufactured like this at the factory.
I only meant to add one photo 🤦‍♀️

Hi, looking at these photos there maybe a cushion missing. It takes two seat cushions + one big back cushion + two slim cushions to go right across the van, perhaps they just haven’t included on photo

Sue

I think this is all we are going to get which is why I need to order some foam so we can make up the double bed. Thanks-it’s a puzzle to work it out.

Thanks

6B1C2EE3-40C1-4972-B0BF-341E18116A7C.jpeg - Bild entfernt (keine Rechte)It looks a lovely van, you may only need one cushion, do you know what year it is, it looks like ours which is a 2012.
Maybe worth asking if they have the other cushion, as the one that’s not shown is the one we have surplus when we make two large singles, I’ve added numbers to the photo, it’s cushion no 5 I can’t see on your photos, I can measure ours tomorrow.

Maybe you could try adding the foam from the cushion with the fitting cover, to the one with the baggy cover. If it fits then that should give the size for the missing cushion. You would be missing one of the small covers.

Hi -still have to order the foam. I think I need two slim and one big to replace the cut up ones. Or maybe one big and one slim? Could you possibly measure them as we pick up the van in the Netherlands and sleep in it that night! Thanks

Our one has the draw unit on the back and we have base and back cushions that sit either side of the cupboard unit