replacing the water pipes that run from the container to the cold water sink taps

already mentioned else where we whip the pump out of container and rest pumps in the sink when refilling container, so these pipes are longer that standard eriba.
we did this to stop the water mess on floor from jug with pump in falling over at the wrong time

there is one jubilee clip on the container tops undone by a flat bladed screw driver and a need for hot water to soften the pipe end to enable push fit to tap, amazing how these stay leak free at the tap

our kitchen pipe just removed is 70 inches long this measurement includes for the cut off of 14inches for the pipe between container top and pump
or
2inches shy of 6 foot
or
178cm


and the shower water closet tap pipe is 50 inches long this measurement includes for the cut off of 12inches for the pipe between water container top and pump
or
4ft 2inches
or
127cm

the inner size of hole in pipe is measured by verniers 7mm
outer pipe measurement is 11mm

wont mention the total length incase you decide to buy enough pipe for another change

we bought a length from Jandi a couple of years back and this is second time fitting cutting where needed

hope this helps

P

kettles boiled back into the eriba