#1

Motor mover transfer

in Anything Eriba-related Fri Jan 20, 2017 6:25 pm
by Mark Askew (deleted)
avatar

Hi All,
Anyone know if it is possible to transfer a mover from a triton to a troll, are they compatible, do you need any additional fixing plates?
Thanks
Mark


Scroll up

#2

RE: Motor mover transfer

in Anything Eriba-related Fri Jan 20, 2017 7:30 pm
by gattim (deleted)
avatar

Depends on the layout of the chassis, you would need to check where the cross members are.


Scroll up

#3

RE: Motor mover transfer

in Anything Eriba-related Sat Jan 21, 2017 7:09 am
by zippy | 70 Posts

we had ours swapped from a triton to a troll and did require a different mounting kit, our new troll was 10cm wider than the triton so the mover width had to be adjusted also, it was a reich type


Randa france likes this post!
Scroll up

#4

RE: Motor mover transfer

in Anything Eriba-related Sat Jan 21, 2017 9:45 am
by Mark Askew (deleted)
avatar

Yes, I have a reich too. I think you're right about the new mounting plate. I'll check with a local motor mover fitter.
Thanks


Scroll up

#5

RE: Motor mover transfer

in Anything Eriba-related Sun Jan 22, 2017 10:00 am
by cabbie37 | 695 Posts

I fitted a s/h Economy Comfort to my 2002 Troll (540) that had previously been fitted to a Triton (420) I think of a similar age. The brackets that came with it were 227-1035. The ones I had to purchase to fit the mover to my Troll were 227-10366.

hth...


Randa france and like this post!
Scroll up


Visitors
1 Member and 6 Guests are online.

Board Statistics
The forum has 12891 topics and 108069 posts.



disconnected Forum-Chat Members online 1