|
|
Good jobby done today
in Anything that's not Eriba-related. Thu May 25, 2017 5:42 pmby hampshireman (deleted)

Karchered the front brick sets today. Borrowed a light weight small rotary machine and while I washed, Carole scrub...no she didn't, she came behind with the yard broom and made sure the dirty water went to drain. Had to park the car where our neighbours usually do on the road and then the Eriba part on the pavement and part on the grass. Felt it was much better than high pressure as that would wash all the grit and sand from the joints.
Puck 225L pushing CMax 1.9TDI Ghia

RE: Good jobby done today
in Anything that's not Eriba-related. Thu May 25, 2017 6:23 pmby Julie Grafo •


RE: Good jobby done today
in Anything that's not Eriba-related. Thu May 25, 2017 8:12 pmby scouteralf •


RE: Good jobby done today
in Anything that's not Eriba-related. Thu May 25, 2017 8:37 pmby Eribanut (deleted)

Replaced the rubber seal/trim around the pop top. Took 2 mins to get the old one off 4 hours to get new one fitted. Very sore hands now
Sermo datur cunctis; animi sapientia paucis
Tempus fugit; carpe diem

RE: Good jobby done today
in Anything that's not Eriba-related. Fri May 26, 2017 7:11 amby rambling robin (deleted)

Cleaned out the gutter, set up the water butts, cut the grass, hung out the washing, swept the patio and tried to reduce the burr in the awning rail a bit more 'cos Hymer actually fitted it with a join on the side where you fit the awning.......using an awning rail tool and some very fine emery. Want to make sure it's all nice and lovely for the new Wigo Vision canopy to try out today.
Neurotic Kia Sportage trundling MegaPuck 410

RE: Good jobby done today
in Anything that's not Eriba-related. Fri May 26, 2017 1:52 pmby Eribanut (deleted)

Tom, I bought the seal from Seals Direct. Purchased about 6 months ago but found it impossible to fit as it was so cold at the time. Jandi was selling replacement seal for £9:00/metre whereas AL price was £20/metre
The one I chose which is same as other folks recommended was ETS 1556. Not same profile as original but I believe better. Difficult to fit as indicated but did find after struggling using brute force that applying PTFE spray in the seal channel made it a lot easier.
ETS 1556 is £3.82/metre
http://www.sealsdirect.co.uk/shopping.as...partmentId=3#23
Washing pop-top material today while sun is shining !
Sermo datur cunctis; animi sapientia paucis
Tempus fugit; carpe diem

RE: Good jobby done today
in Anything that's not Eriba-related. Fri May 26, 2017 6:55 pmby hampshireman (deleted)

We set to and did the patio round the back this morning. Looks good, having just sat on it with aperitifs before dinner..
Puck 225L pushing CMax 1.9TDI Ghia

![]() 0 Members and 101 Guests are online. |
![]()
The forum has 13002
topics
and
108637
posts.
|

