Front marker lights
Hi
I wonder if there's anybody out there that can help me? I have a 320 GT and need to change a bulb on one of the front marker lights. I took the reflector off but can't seem to get into the back of the unit to change the bulb. Has anybody any experience of this?
Any help will be much appreciated.
Best regards
Peter
RE: Front marker lights
in Anything Eriba-related Fri Feb 26, 2016 10:32 pmby Randa france • | 13.283 Posts
Hi Peter.
I'm not sure what the problem is here. On our '99 Eriba, the lower front side light refectors are just held in by the rubber gaskets and once removed the bulbs are exposed.
The top lights (red/white) reflectors are screwed in top and bottom and once the reflector and back plate is removed, it's a little bit of a fiddle to remove and replace the 12v 5w festoon bulb through the back plate but on our model at least, it is possible.
Perhaps it's a different set up on newer models?
Randa
1999 Eriba Troll 530 pushing a VW Touran 2L TDi Match
RE: Front marker lights
in Anything Eriba-related Sat Feb 27, 2016 9:29 amby Peter Rhind (deleted)
Hi Randa,
Thanks for your reply. I've attached a picture showing the front marker light. Are these different from yours? When you take the reflector off the whole unit seems to be stuck together and you can't get to the bulb.
I wonder if you or anybody else knows whether you need to have these on by law?
All the best Peter
Caravan2.jpg
RE: Front marker lights
in Anything Eriba-related Sat Feb 27, 2016 9:40 amby Pepé Le Pew • | 2.752 Posts
Quote: Peter Rhind wrote in post #3It seems that the answer to this is yes. Have a look here. Table VI. The relevant specs are in Schedule 2, part 1.
I wonder if you or anybody else knows whether you need to have these on by law?
.
yy-R56kh
RE: Front marker lights
in Anything Eriba-related Sat Feb 27, 2016 10:32 amby Randa france • | 13.283 Posts
Hi Peter.
Unfortunately your pic didn't come out but below is a photo of the ones on our van. Looking through the gallery it does look as though this is standard for some of the newer vans as well.
When I changed the bulb in ours last Autumn I seem to remember that when I removed the screws, the reflector unit came away from the van body and there was a semi back plate on it. The dud bulb was difficult to get out through a slot in the back plate (a small screwdriver did the trick) but the new festoon bulb was fairly easy to push through the slot into the cradles.
marker-light.jpg - Bild entfernt (keine Rechte)
What age is your van?
Randa
1999 Eriba Troll 530 pushing a VW Touran 2L TDi Match
How to include images in a post
Click the link above
Forum moderator
Vauxhall Insignia Sri 1.8 petrol 2015 towing 2006 Triton 430 import
RE: Front marker lights
in Anything Eriba-related Sat Feb 27, 2016 2:10 pmby Randa france • | 13.283 Posts
The marker lights on my 2006 triton are made by Hella
Werbung: http://www.ebay.co.uk/itm/HELLA-Red-White-Side-Marker-Light-lamp-HYMER-ERIBA-camper-motorhome-caravan-/361283703198
Which should take this type bulb
Werbung: http://www.ebay.co.uk/itm/10x-Genuine-Osram-Original-12v-T4W-BA9S-233-4w-Clear-Bulbs-3893-/390978696499?hash=item5b08257533:g:a5MAAOSwrklVZvZ0
Which usually require a gentle push in and a twist to release and align the pins before pulling out ........... fitting a new one is the same in reverse
The following contents have been linked to this post:
Forum moderator
Vauxhall Insignia Sri 1.8 petrol 2015 towing 2006 Triton 430 import
RE: Front marker lights
in Anything Eriba-related Sat Feb 27, 2016 3:54 pmby Peter Rhind (deleted)
Success!!!
The push and twist worked but it was very stiff and I had to use pliers. The bulb is in like a plastic lamp-holder with a bayonet fitting.
Thanks you-all
Visitors
1 Member and 29 Guests are online. |
Board Statistics
The forum has 12892
topics
and
108066
posts.
|