#16

RE: Pop Top Rubber Seal

in Anything Eriba-related Sun Jul 19, 2015 5:23 pm
by ellen (deleted)
avatar

We took our rubber off the pop top last week and gave it a good scrub, it's come up like new and it gave us the opportunity to clean the pop top edge as well. Doods also got some new grab handles fitted and a new decal fitted, he looks very posh now.


Proud owners of Doo-Dah our Familia 310
Scroll up

#17

RE: Pop Top Rubber Seal

in Anything Eriba-related Sun Jul 19, 2015 5:33 pm
by Aaron Calder | 3.834 Posts

I wish you'd stop teasing poor Rodders, Pete. You're keeping him from searching for that replacement bog lid that he promised me.


Forum Administrator
2003 Triton 420 and Audi A4 2.0Tfsi S-line SE Cabriolet


Last edited Wed Jul 26, 2017 11:19 pm | Scroll up

#18

RE: Pop Top Rubber Seal

in Anything Eriba-related Tue Jul 21, 2015 6:59 am
by Rabiedmushroom (deleted)
avatar

Yeah yeah, I know about you gentlemen getting confused over a couple of inches...

So even if there is a rubber seal present, either straight down on the roof or facing inwards...

you may as well just get simple trim because it doesn't actually function as a seal?

I think I'd still be tempted with replacement similar to my first pic above, and all the way round.
Owned too many Minis that dribbled water in through rear windows with old shrunk rubbers!
Suzy


Scroll up

#19

RE: Pop Top Rubber Seal

in Anything Eriba-related Tue Jul 21, 2015 8:59 am
by Pepé Le Pew | 2.752 Posts

Quote: Rabiedmushroom wrote in post #18
Yeah yeah, I know about you gentlemen getting confused over a couple of inches...
Speaking as a barely adequate gentleman who genuinely thought that all the edgings were the same, I can only apologise and suggest that you replace like with like.

.


Scroll up

#20

RE: Pop Top Rubber Seal

in Anything Eriba-related Tue Jul 21, 2015 9:22 am
by Aaron Calder | 3.834 Posts

I may be wrong on this but it strikes me that the primary purpose of the rubber seal (apart from preventing abrasion between the pop-top and the roof) could be to prevent road dirt getting onto the canvas skirt while towing in bad weather.


Forum Administrator
2003 Triton 420 and Audi A4 2.0Tfsi S-line SE Cabriolet


Last edited Wed Jul 26, 2017 11:18 pm | Scroll up

#21

RE: Pop Top Rubber Seal

in Anything Eriba-related Tue Jul 21, 2015 9:48 am
by crow (deleted)
avatar

The top two rubbers are boot seals, are they not ?
Eribas I have seen usually have the ordinary
edging strip (except for Petes, of course, which
are bound to be different)


Some OAP's Should Get Holiday Pay


Last edited Tue Jul 21, 2015 10:01 am | Scroll up

#22

RE: Pop Top Rubber Seal

in Anything Eriba-related Tue Jul 25, 2017 1:50 pm
by eriba4us (deleted)
avatar

On the subject of roof trim/seals, I have just spoken to a company called Seals+Direct. They told me they supply window and roof rubber seals to Automotive Leisure. Their premises are quite near AL and they have some knowledge of Eribas. I don't know what AL charge for renewing the roof seal but I just purchased a new seal for my 2007 Triton 430 for under £50.00, including next day delivery. The profile is ETS 1556 and can be viewed on Seals+Direct web site.


/Users/davidcooper/Desktop/P1030081.JPG
likes this post!
Scroll up

#23

RE: Pop Top Rubber Seal

in Anything Eriba-related Tue Jul 25, 2017 2:06 pm
by hob (deleted)

Vauxhall Insignia Sri 1.8 petrol 2015 towing 2006 Triton 430 import

Forum moderator
Scroll up

#24

RE: Pop Top Rubber Seal

in Anything Eriba-related Wed Jul 26, 2017 3:38 pm
by eriba4us (deleted)
avatar

New seal ordered yesterday (Tues 25th). It arrived by 11.00 am today (Wed 26th) and is now fitted. When I removed the old seal I found the pop top was not cut evenly but this profile enabled a reasonably good finish....much better than the old one anyway. My only advice would be to clean the roof where the old seal was removed and install the new seal WITHOUT the aid of washing up liquid as a lubricant. It pops on better when dry and stays in place. Total cost of the job - £49.60.


/Users/davidcooper/Desktop/P1030081.JPG
Randa france and like this post!
Scroll up

#25

RE: Pop Top Rubber Seal

in Anything Eriba-related Wed Jul 26, 2017 4:35 pm
by Eribanut | 2.026 Posts

Quote: eriba4us wrote in post #22
On the subject of roof trim/seals, I have just spoken to a company called Seals+Direct. They told me they supply window and roof rubber seals to Automotive Leisure. Their premises are quite near AL and they have some knowledge of Eribas. I don't know what AL charge for renewing the roof seal but I just purchased a new seal for my 2007 Triton 430 for under £50.00, including next day delivery. The profile is ETS 1556 and can be viewed on Seals+Direct web site.


I believe AL charge £9.00/metre for same trim which for the Troll you need 9 metres so £81.00 plus postage. Replaced mine using same from Seals Direct 3 months ago.


Sermo datur cunctis; animi sapientia paucis
Tempus fugit; carpe diem
Scroll up

#26

RE: Pop Top Rubber Seal

in Anything Eriba-related Wed Jul 26, 2017 8:28 pm
by eribanaut | 1.228 Posts

I've just reread this thread and no one ever did answer the original question asked, "how much rubber seal to go round a Troll pop top"
Dave


Citroen C4 auto 1.6 Hdi Troll 552 - 2005
Scroll up

#27

RE: Pop Top Rubber Seal

in Anything Eriba-related Wed Jul 26, 2017 8:40 pm
by Pepé Le Pew | 2.752 Posts

Quote: eribanaut wrote in post #26
I've just reread this thread and no one ever did answer the original question asked, "how much rubber seal to go round a Troll pop top"
Dave
It says in the previous post. 9 metres.

.


RF18-668/2
Scroll up

#28

RE: Pop Top Rubber Seal

in Anything Eriba-related Wed Jul 26, 2017 10:50 pm
by eribanaut | 1.228 Posts

Quite right I missed it, so only 2 years to get an answer then.
Dave


Citroen C4 auto 1.6 Hdi Troll 552 - 2005
Pepé Le Pew and Eribanut like this post!
Scroll up

#29

RE: Pop Top Rubber Seal

in Anything Eriba-related Thu Jul 27, 2017 8:57 pm
by highmiler | 367 Posts

9metres and two inches to cover the gap we all have!!!!!!!


Highmiler.Troll 530GT and Skoda 2.0 TDi
Eribanut likes this post!
Scroll up

#30

RE: Pop Top Rubber Seal

in Anything Eriba-related Mon Jul 31, 2017 8:25 am
by Jezzer (deleted)
avatar

Hi,

so our 78 triton does not have a pop top 'seal'. The edge of the pop top and the roof of the caravan were always touching each other so I decided to get a 'seal'. Base on the recommendation I purchased 9m of ET1556.

Its now fitted and its great. The hooks inside the caravan are a little harder to get into place now due to the extra addition of the seal but I expect this will soften over time.

The pop top looks better for the addition of the seal and it any one is considering this (as they don't have a pop top seal) then I think it's a worthy piece of maintenance.

cheers
jezzer


Eribanut likes this post!
Scroll up


Visitors
3 Members and 91 Guests are online.

Board Statistics
The forum has 12892 topics and 108082 posts.



disconnected Forum-Chat Members online 3