Want to replace this as its getting tired but need to know the length to order replacement. We have 2007 Troll which is at present in storage so cannot measure.
Can anyone advise on the the circumference of the pop top as our Eriba is in storage at this time

Thanks

Mike

Hi, where's a good place to purchase the trim?
Mines got a 2" gap at the rear so I also could do with replacement strip to keep it watertight.

If it's only a 2 inch gap I would'nt worry it's not a waterproof strip as such, more of a bump stop (according to Jandi) if you look on Ebay it is available in a variety of colours

A gap around 2 inches at the back is normal.

I have no idea if my top seal has been replaced by previous owners. If I do replace it, what OUGHT it look like?
Should the squishy rubbery seal be face down onto the roof, or facing in to to the opening? (1989 round pop-up Puck, silver & red stripe model)
Thanks.

Recently replaced pop top trim on my Troll. 2007 model. easy job, including cleaning edge, 20 mins. Requires approx 9 metres

I bought from Jandi as they were £8 per mtr less than the same trim from Poole. They even reduced the quoted price when the Euro fell against the £ between order and delivery.

There are cheaper options, but I used the genuine Hymer parts

The gap is to allow some ventilation to the canvas,
the rubber is not a watertight gasket merely finishing
trim for the fibreglass top.

http://www.sealsdirect.co.uk/shopping.asp?intDepartmentId=8

Gap? Bof !! (Said with Gallic shrug).

2 gaps in this thread......one between the dropped pop top and the roof and the other where the cut ends of the trim do not quite meet.

Your troll must be the odd one out, all the Eriba I have seen have the gap.

All of them? I am a foot taller than you Gimli

I've just looked at the photos of our 230. That didn't have a gap either, so there.
You were born lucky Pete (to make up for the beard matey)

Well hello Dolly, you're lookin' swell Dolly

wuv oo to Pete